847-956-6200 - OEM's Only. No consumer sales.

Solenoid Manufacturer and Supplier
Americor Electronics, Ltd. manufactures and supplies solenoids to original equipment manufacturers and distributors. All Solenoids have two main components, the coil winding or wound bobbin, also called the energy converter and the plunger. By energizing the coil winding, the plunger is pulled in the desired direction and either opens or closes a circuit. Our international and domestic solenoids include open frame solenoids, flapper solenoids, tubular solenoids and special & valve solenoids. If a standard solenoid does not fit your next project, contact our staff for custom solenoid options. Solenoids can be designed to meet specs and are guaranteed maximum function and cost efficiency. Our capabilities include design, development, sample production and first article approval with full documentation.  All of our products are 100% tested, ISO 9001-2015 certified and RoHS Compliant. 

Standard Specification For  Americor Solenoids

Standard Testing Conditions

Ambient temperature 20° C, Relative humidity 65%

Rated Voltage and service condition     

As per individual specification

Testing Position

Plunger under load in vertical position

Pull Force

As per individual specification ( Characteristic curves are based on values measured immediately after application of specified voltage at normal temperature.

Residual magnetism

As per individual specification

Testing power supply

DC regulated power supply ( Ripple: 1m Vrms or below )

Insulation Resistance

500 VDC, 50 MW or above ( normal temperature and normal humidity). Otherwise as per individual specification

Withstand Voltage

500 VAC or 1000 VAC, 50/60 Hz for 1 minute ( normal temperature and normal humidity ), Otherwise as per individual specification.

Temperature Rise

65 ° C or below on continuous rating operation. Temperature Rise in intermittent operation as per individual specification ( determined from change in solenoid coil resistance )

Life Test

Solenoid withstanding intermittent operation of specified duty cycle using specified voltage, load and stroke for number of cycles specified by individual specification.

Lot Number and Model marking

As per our standard

 

Solenoid Basic Construction:
  1. Frame: Support for Magnetic circuit and mounting parts
  2. Front plate: Support for Magnetic circuit and mounting parts
  3. Bobbin: Coil Winding
  4. Pipe: Plunger moving guide
  5. Plunger: Electric magnetized metal
  6. Stopper: Force to stop plungers forward movement
  7. Input: Power Input Terminals
  8. Plate: Plate for input Terminals
  9. Magnet Wire: For Coil Winding
  10. Tape: Tape to insulate Magnet Wire
Solenoid Manufacturer
Solenoid Basic Construction